How much does chimney repointing cost?

A typical domestic chimney repoint usually sits in the high three-figure to low four-figure range depending on access and stack size. You'll get a written quote before any work starts.

Do I need scaffolding for chimney work?

For most chimney work yes — it's the only safe way to work properly on a stack. The cost is included in our quote.

How long does a chimney rebuild take?

A straightforward rebuild down to the roofline and back up typically takes 2–4 days depending on size and weather.

Can you remove an unused chimney stack?

Yes. We can take a stack down to roof level, weather over with matching tiles or slate and lead, and remove the resulting waste.

How long does chimney pointing last?

Properly mixed and applied pointing in the right material typically lasts 30+ years. Bad pointing fails in one.

Will my chimney leak after repointing?

Not if it's done right. Most 'still leaking after repointing' jobs are either flashings, flaunching, or wrong-mix mortar — we address all of these as standard.

Do you fit bird guards and cowls?

Yes. We fit a range of bird guards and cowls to suit working flues, gas appliances and capped-off stacks.

Is chimney work covered by your guarantee?

Yes — every chimney repair, rebuild and repoint we carry out comes with a written workmanship guarantee.

Brick chimney with four pots and stainless bird spikes after repair

Chimney Repairs Spennymoor

Chimney Repairs & Repointing
in Spennymoor & County Durham.

Repointing, lead flashings, cap and cowl work, and structural rebuilds — your chimney sealed properly against the worst of British weather.

Get My Free Estimate 07785 964863

12+ years' experience · written guarantee on every job

12+

Years' experience
100%

Workmanship guarantee
24/7

Emergency call-out
Free

On-site estimates

Overview

What it is, who it's for,
and when it's needed.

What it is: Full chimney services — repointing weathered mortar joints, replacing lead flashings, fitting cowls and caps, rebuilding crumbling stacks and reseating chimney pots.
Who it's for: Homeowners with chimneys showing damp staining inside, crumbling pointing, leaning brickwork, missing pots or cowls, or a stack that's clearly past its best.
When you need it: When you spot internal damp near the chimney breast, when pointing falls into the gutter, when bricks become loose, when birds nest in open pots, or when survey reports flag the chimney as defective.
Why it matters: Chimneys take more weather than any other part of your roof. They lean into wind and rain on every side, and small problems escalate quickly. A failing chimney is also a serious safety risk to people below.

Don't Wait

What it costs to leave it.

Chimneys are exposed on all four sides and 24 hours a day. Weather works at them constantly — and once they start to fail, they fail quickly.

Risks of ignoring it

Crumbling pointing lets water track through brickwork, causing damp on the chimney breast inside.
A leaning stack risks dropping bricks onto the roof, the garden, or worse.
Open pots become bird nests — blocking flues and creating fire risk.
A failing flaunching (the mortar at the top) lets water down the inside of the stack into the property.

Common mistakes to avoid

Sealing pointing with the wrong mortar — a hard mix cracks and fails in one winter.
Ignoring lean — it always gets worse, never better, and rebuilds get more expensive over time.
Capping a working flue without proper venting — inviting condensation problems.
DIY repointing without raking out properly — looks fine, lasts a season.

Our Process

A clear, honest path
from quote to guarantee.

1
Safe Access & Inspection

Scaffold or tower as required, full inspection of stack, flaunching, pots, flashings and pointing.
2
Diagnosis & Quote

Clear written quote stating exactly what's being repaired or rebuilt — no scope creep on the day.
3
Repair Or Rebuild

Repointing in matched mortar, lead flashings renewed where needed, pots reseated, or full rebuild if structurally required.
4
Cap & Finish

New flaunching at the top, cowls or caps fitted as needed, final pointing touched in.
5
Sign-Off & Guarantee

Photos of finished work, scaffold removed, written workmanship guarantee in your hand.

Why It Pays

Concrete benefits.
No vague promises.

Stops Internal Damp

A properly sealed chimney ends the recurring damp patches on your chimney breast.
Long Life

Quality repointing in the right mortar mix typically lasts 30+ years.
Structural Safety

A rebuilt or stabilised chimney removes the falling-brick risk to people below.
Bird-Proof

Cowls and caps stop nesting and protect the flue without trapping condensation.
Heritage Friendly

We can colour-match mortars and reuse original bricks for period properties.
Fully Guaranteed

Every chimney job comes with a written workmanship guarantee.

Deeper Detail

Materials, methods
and the full picture.

Everything below is what we'd want to know if it were our roof.

Common chimney problems we fix

Most chimney work falls into these categories — often more than one needs doing on the same visit.

Repointing weathered mortar joints in matched lime or sand-cement mix
Renewing lead flashings around the base of the stack
Re-bedding loose chimney pots and renewing the flaunching
Fitting bird guards, cowls and rain caps to disused or working flues
Removing redundant stacks down to the roofline and weathering over
Full structural rebuilds where leaning, cracking or spalling is severe

Mortar mixes — why they matter

Chimneys move with thermal cycling and exposure. They need a mortar mix that flexes with that movement. We typically use a 4:1 sand-and-cement mix with plasticiser for modern properties, and lime mortar mixes for older and listed buildings. The wrong mix cracks, lets water in, and fails inside a couple of seasons.

Flashings, flaunching and pots

A chimney is only watertight if every detail works together: lead flashings around the base, a sound flaunching at the top, properly seated pots and a working cowl. We tackle the chimney as a system, not a list of disconnected fixes — that's what stops the leak coming back.

Chimney work across Spennymoor and County Durham

We carry out chimney repairs and rebuilds across Spennymoor, Durham, Bishop Auckland, Ferryhill, Shildon, Chilton, Byers Green, Darlington and Newcastle. Many of our chimney jobs are booked alongside roof repairs or leadwork to share access and scaffold costs.

Common Questions

Straight answers
from a local roofer.

Can't find what you're looking for? Call Sean directly on 07785 964863.

Related Services

Areas We Cover

Local to you,
across County Durham.

Ready When You Are

Get a clear quote for chimney repairs & repointing —
usually within 24 hours.

Free, on-site estimate. No pressure, no upsell, no obligation. Just an honest assessment from a local roofer who answers his own phone.

Written guarantee on every job Fully insured Local family-run business

Speak To Sean

Quotes returned the same day.

07785 964863 Request Free Estimate

Chimney Repairs & Repointing in Spennymoor & County Durham.

What it is, who it's for, and when it's needed.

What it costs to leave it.

Risks of ignoring it

Common mistakes to avoid

A clear, honest path from quote to guarantee.

Safe Access & Inspection

Diagnosis & Quote

Repair Or Rebuild

Cap & Finish

Sign-Off & Guarantee

Concrete benefits. No vague promises.

Stops Internal Damp

Long Life

Structural Safety

Bird-Proof

Heritage Friendly

Fully Guaranteed

Materials, methods and the full picture.